18% OFF over $188 | Code: XMAS18

22% OFF over $268 | Code: XMAS22

22% OFF over $268 | Code: XMAS22

Votre panier

Votre panier est actuellement vide.

Check out this collection, 20% OFF!

6 Tape-in Extensions Mistakes And How to Fix Them

6 Tape-in Extensions Mistakes And How to Fix Them?

6 Common Tape-In Extension Application Mistakes

1.  MISTAKE: Tapes are visible when the hair is pulled back

     SOLUTION: Allow at least 1 inch of space from the hairline

Without enough natural hair density at the hairline, that tape WILL be visible. Go at least an inch away from the hairline and test what the hair looks like when pulled back (even at multiple angles) to make sure the tape is hidden. For fine or thin hair, allow even more space.

2.  MISTAKE: The tape is installed too close the scalp, causing tension and pain

     SOLUTION: Allow between ¼ and ½ inch between the scalp and the tape

Installing tapes directly next to the scalp does not allow the client’s hair to naturally fall, which in turn causes buckling and tension on the hair—and that means the extensions could be painful and won’t last as long. The proper distance from the scalp for tape-in application is ¼ to ½ inch, which allows the hair to naturally fall and won’t add tension.

3.  MISTAKE: Forcing too much hair between tapes

     SOLUTION: Take thin sections

Too much hair between tapes prevents the adhesive from properly sealing, and the extensions won’t last as long. If your tail comb can easily fit between the tapes, that means there is too much hair in the section and the adhesive isn’t sealed. Instead, take thin sections—you should be able to see through them—so the adhesive can seal properly.

4.  MISTAKE: Using your fingers to seal the tape

     SOLUTION: Use the Connector Tool

The more you touch the adhesive tabs, the more oils from your fingers can break down the adhesive—again, leading to extensions not lasting. Advises using clips or a tail comb to place the tape tabs, then using the Connector Tool to seal them. Squeeze the tab a few times, then squeeze both edges of the tapes to ensure a totally sealed bond that will keep water and moisture out.

5.  MISTAKE: Applying extensions at a strong diagonal, which can cause tension

     SOLUTION: Take a softer diagonal

A diagonal section that is too extreme means the client’s hair won’t lay at natural fall—it will slightly curve up and THEN down. Installing an extension here will cause tension, which equals potential pain and decreases the extension application’s longevity. If you want to tape on a diagonal to fill in the front, follow the way the hair wants to lay.

6.  MISTAKE: Adhesive tabs are misaligned and won’t seal

     SOLUTION: Be precise in application


Precision DOES matter in application. If the tabs are even slightly misaligned, you won’t get a proper seal. Be precise in lining up the adhesive tabs, and seal with the Connector Tool. This is crucial to keeping moisture out and achieving long-lasting extensions.

Article précédent
Poste suivant

Laissez un commentaire

Veuillez noter que les commentaires doivent être approuvés avant d'être publiés.

Blog posts

Full Shine® Human I Tip Hair Extensions

Tips for Matching Keratin I Tip Hair Extensions with Daily Styling

In the pursuit of fashion and beauty, hairstyle is undoubtedly an important part of showing personality. As a dark horse in the hairdressing industry, Keratin I Tip Hair Extensions’ high-quality...

En savoir plus
Full Shine Hair Extensions Safety Guidance

How Can I Prevent the Safety Hazards Associated with Hair Extensions?

Hair extensions offer a quick and appealing way to change your look, add volume, and achieve those dreamy locks you've always wanted. However, like any beauty enhancement, they come with...

En savoir plus